Check out our new Prevention line of spa and salon disinfectants. Available  now.
Click here to learn about our new Rejuvenate Special Edition Wipes

Cleaning and disinfecting your footbaths may not be the most fun thing to do, but it’s arguably one of the most important. Disease-causing germs such as bacteria, viruses, and fungi can use your footbaths as a quick and easy way to spread from one person to the next. But there’s good news – with regular cleaning and disinfection, you can stop these germs in their tracks and keep your footbath clean and disease-free. 

Step 1: Make Sure Your Client is Footbath-Ready

Ensure that your clients don’t have any sores or wounds on their skin, including scratches, insect bites, or anything else that could weaken the skin. Have a strategy to explain to your client that they should wait until healed to use the footbath, as germs can enter the footbath from breaks in the skin. In addition, arrange for clients to use your footbaths before doing anything that could risk breaking the skin, such as a pedicure or wax. Again, this helps ensure that the client is not transmitting harmful germs into the footbath.

Step 2: Disinfect Between Clients

After each client, your footbaths should be properly cleaned and disinfected by following a few simple steps:

1) Drain the basin or bowl of the footbath and remove any visible dirt or debris that may be leftover.

2) Clean the basin and all other surfaces with a detergent or a one-step cleaner/disinfectant such as Rejuvenate™.  Use a brush to evenly scrub all surfaces to loosen and remove any dirt residue on the surface. Rinse the footbath with clean water and drain.

3) Disinfect with an EPA-registered hospital grade disinfectant. This step is different depending on whether a circulating or non-circulating system is used.

a. If you’re using a non-circulating footbath, wipe or spray your disinfectant evenly across the surface of the basin. Ensure that the disinfectant solution is allowed to remain wet on the surface for the required contact time, which can be found on the product label. Look for the fungicidal claim, which usually is 10 minutes.

b. If you’re using a circulating footbath, start by filling the basin with clean water above the jet line. Then, add the amount of disinfectant required to reach the correct concentration. For instance, if using Rejuvenate™ concentrate, add the concentrate to the basin to result in a concentration of 1:16 or 8 oz. per gallon. In some cases, a silicone-based antifoam may come in handy to prevent excess foaming during disinfection. Turn on the footbath and allow it to circulate for 30 seconds to allow the disinfectant to get in the pipes and disinfect hard-to-reach areas. Then, turn off the footbath and enable the solution to sit for the required contact time.

4) Once the disinfection step is complete, drain the footbath and rinse with clean water. In a circulating system, turn on the footbath for 30 seconds to complete the rinse step. Drain the footbath again.

Step 3: The Deep Clean

At the end of the day, your circulating footbaths may need a little extra attention to ensure everything is clean and ready to go for the next day. After draining these footbaths after the last client of the day, remove any filter screens, jets, and any other removable parts from the basin. Use a clean brush to scrub these pieces with a disinfectant such as Rejuvenate™, and rinse. Place the pieces back into the basin and disinfect, following the same steps as above.